Header image

www.DurabakM26.com

For High Durability Deck Coatings
Indoor Decks & Outdoor Weather Decks

Cote-l Industries, Inc.

   | Contact Us

Color Chart

PDF Files:

Tip Sheet

Safety Data

Flyer (side 1)

Flyer (side 2)
 
 


 
 
Click for a printable PDF version of Durabak M26™MSDS Safety Data

Cote-l Industries, Inc.
1542 Jefferson Street
Teaneck, NJ 07666
Tel: 201-836-0733
Fax: 201-836-5220
www.cotelind.com
Email: msds@cotelind.com
Material
Safety
Data
Sheet
PHONE NUMBERS:
INQUIRY: 201-836-0733
EMERGENCY: 800-255-3924
DATE OF PRINTING: 11 October 2006
HAZARD RATINGS:
[1=Slight 2=Moderate 3=High 4=Extreme]

HEALTH: 1 FLAMMABILITY: 3 REACTIVITY: 0
IDENTITY: Protective Coating -- DURABAK - M26™/ DURABAK 18 - M26™
SECTION I
MANUFACTURER'S NAME:
ADDRESS:
DATE MSDS PREPARED:
NAME OF PREPARER:
COTE-L INDUSTRIES, INC.
1542 Jefferson Street,
Teaneck NJ 07666 11 October 2006
Henry B. Boyles
SECTION II - HAZARDOUS INGREDIENTS / INFORMATION
HAZARDOUS COMPONENTS: none
POTENTIALLY HAZARDOUS INGREDIENTS:
CAS NUMBER PERCENTAGE
BY MASS
Light aromatic petroleum solvent 64742-95-6 23.0
Medium aliphatic petroleum solvent 64742-88-7 1.2
NOTE: SEE SECTION IX: POSSIBLE REPORTING CRITERIA
SECTION III PHYSICAL / CHEMICAL CHARACTERISTICS
Boiling Point, initial: 309°F
Flash point (ASTM D 3278) 122.90F
Vapor pressure (mmHg @ 200C) <20
pH: n/a
Solubility in Water: forms solid gel
Appearance and Odor: pigmented liquid;
hydrocarbon
Specific Gravity (water=1):
1.03
Melting Point: n/a
Evaporation Rate (Butyl Acetate=1): n/a
SECTION IV - FIRE AND EXPLOSION HAZARD DATA
Flash Point (Method Used):
Flammable Limits:
UEL:
Extinguishing Media:
Special Fire Fighting Procedures:


Unusual Fire Fighting Hazard:
122.9°F (ASTM D 3278)
1.0
7.0
foam, dry chemical, carbon dioxide
Vapors can form explosive mixtures with air. Vapors are heavier thanair and will flow along surface to distant ignition sources and flashback.
Keep away from heat, sources of ignition, oxidizers.
SECTION V - REACTIVITY DATA
Stability:
Incompatibility (Materials to Avoid):
Hazardous Decomposition Products:
Hazardous Polymerization:
Stable
strong oxidizing agents, water
carbon monoxide
WILL NOT OCCUR
SECTION VI - HEALTH HAZARD DATA
Route(s) of Entry:
Inhalation?
Skin?
Ingestion?
Eyes?

Health Hazards (Acute and Chronic):
Ingestion:
Inhalation:
Skin Contact:
Eye Contact:

moderate
low
low
moderate


Will cause severe distress in mouth and throat.
Vapors can cause respiratory irritation.
May cause blistering on contact.
Can cause blistering and severe pain.
Carcinogenicity:
NTP?
IARC Monographs?
OSHA Regulated?
ACGIH 1987-88

Medical Conditions Aggravated by Exposure:

Emergency and First Aid Procedures;
Ingestion:

Inhalation:

Skin Contact:
Eye Contact:

NO
NO
NO
NO

None known


Get medical attention immediately. Do not induce vomiting. Never give anything by mouth to an unconscious person.
Remove from contaminated area. Contact physician immediately.
Wipe with dry cloth or paper. Clean with solvent.
Flush with large amounts of water as quickly as possible. Get medical attention quickly. Continue flushing until helps arrives.
SECTION VII - PRECAUTIONS FOR SAFE HANDLING AND USE
Steps to be Taken in Case Material is Released orSpilled:
Small Spills:
Large Spills:

Waste Disposal Method:

Steps to be taken in Handling and Storage:


Other Precautions:


Adsorb on suitable material (vermiculite, saw dust, sand). Sweep up.Contain Spill; adsorb on vermiculite or sand; shovel up and send toregistered landfill.
Contact local authorities for disposal rules.

KEEP CONTAINER CLOSED WHEN NOT IN USE. CLEAN UP ALL SPILLS PROMPTLY. KEEP OUT OF THE REACH OF CHILDREN.
SECTION VIII - CONTROL MEASURES
Respiratory Protection (Specify Type):
Ventilation:
Protective Gloves:
Eye Protection:
Other Protective Clothing or Equipment:
Work / Hygienic Practices:
Application:
Organic vapor filter suggested.
Maintain air movement.
Solvent and chemical resistant required.
Plastic eye protection REQUIRED.
Boots suggested.
WASH HANDS AFTER HANDLING.
Follow instructions; do not overuse product. Follow label directions.
SECTION IX - REGULATORY INFORMATION AND REFERENCES
Sara Title III Reporting Requirements
Section 302
Section 311
Section 312
Section 313
CERCLA / RCRA Reporting Requirements:
CERCLA:
RCRA:
WHMIS:
Biodegradability:
Label Required:
DOT: Air
Ground

No
Yes
Yes
NOT REQUIRED

REQUIRED
REQUIRED
Yes
Biodegradable
Regular product label; Flammable Liquid
Paint, Flammable Liquid, n.o.s., 3, UN 1263, III
Paint, Consumer Commodity, ORM-D
References
Regulatory Standards:

Toxic Substance Control Act List (TSCA):
Permissible Exposure References:

DOT Title 49, Code of Federal Regulations 172, 101
Superfund Amendment Reauthorization Act of 1986, Title III
ingredients listed
Registry of Toxic Effects of Chemical Substances
National Toxicology Program (NTP) Report on Carcinogens
International Agency for Research on Cancer (IARC) Monographs
Occupational Safety & Health Regulations
The information contained herein is based on data available to us and is believed to be correct. However, we make no warranty,expressed or implied regarding the accuracy of these data or the results to be obtained from the use thereof. Vendor assumes no responsibility for injury from the use of the product described herein.